For the complete documentation index, see llms.txt. This page is also available as Markdown.

SNDK Basis

Hold spot SNDK, short the perpetual on Lighter, and collect the funding.

How it works

SNDK Basis is a self-custodial, non-pooled basis trade (cash-and-carry) that earns funding-rate yield in your own account on Lighter. Your account buys SNDK on the spot market and opens a short SNDK perpetual of the same size. Price moves on one side are offset by the other, so your position stays roughly flat while the short side collects funding.

Market details

Parameter
Value

Spot market

SNDK on Lighter

Perp market

SNDK perpetual on Lighter

Deposit asset

USDG on Robinhood Chain

Funding frequency

Hourly

Risk presets

Conservative 2x · Balanced 3x · Aggressive 4x

Minimum deposit

Shown in the app for each risk level

Funding your position

SNDK Basis is funded with USDG on Robinhood Chain. If your funds are on another network, use the in-app Bridge to move them over from any supported chain.

Trading key

SNDK Basis runs through a trade-only trading key on Lighter. The key is valid for 365 days, and you can renew or revoke it at any time from the position's settings.

The key can place and cancel orders, rebalance the hedge in your account, set the position's leverage, and withdraw to your own wallet.

The key cannot send your funds to anyone else, transfer them to another account, or extend or change its own permissions.

If the key lapses without being renewed, the position automatically closes. To renew your key, go to the advanced view, select manage and go to the settings.

Withdrawals

Withdrawing from SNDK Basis takes two steps:

  1. Withdraw from the position. Your funds move from the position to your Lighter account as USDG.

  2. Bridge your USDG out. Use the in-app Bridge to move your USDG from Lighter to your wallet on Robinhood Chain, or to another network.

For bridging out you'll need a small amount of ETH on Robinhood Chain to pay gas.

Get started

Open a position from the Basic quickstart or configure your own automations in the Advanced quickstart.

Last updated

Was this helpful?